All Surface Rejuvenations Plus
The Most Thorough Cleaning Ever, or it's Free!

Flooring Maintenance,
Repairs, & Restorations

Call Now for a FREE Estimate

Call Now for a FREE Estimate!

Tile & Grout Clean/Seal

The Grout and Tile

Cleaning Process…

All Surface Rejuvenations Plus uses a 4 step process to rejuvenate your floor surfaces.  This process not only restores your floors to their original beauty, it also guards your grout from staining and discoloring.

STEP 1.  A cleaning solution is applied to the tile and grout lines and allowed to

dwell for 10 to 20 minutes..  The solution is then worked into the pores to loosen

embedded dirt, grease, oils and other contaminants


STEP 2.  With our Truck-mounted Equipment, we use up to 300 degrees of water and up to 2500psi of water pressure, we thoroughly wash, sanitize, rinse, and extract the dirt, oils and dirty residue out of the pores of the grout and tile into our truck’s recovery tank.  You will see immediate results.  This clean and efficient process is all fluid controlled so there is little over-spray of water or cleaning solution.  Our system allows us to use the high pressure and high heat, without harming your floors, baseboards, cabinets, furniture, etc.   


STEP 3.  Next we dry the floor using high speed air movers which takes approximately 10-30

                minutes.  We are then able to inspect the floor to see the true condition of the grout,

                and can tell at this point if there is any permanent staining or discoloration.


STEP 4. Sealing the grout.  You are happy with the results of the cleaning.  We can go ahead and apply our solvent based, penetrating sealer to the grout for stain protection. Our Grout Sealing process comes with a 1yr/20yr written stain warranty.

For Tile and Grout Photos, Click Here